Sale!

TTP223B 1 Channel Jog Digital Touch Sensor

රු80.00

Jog type: the initial state is low, high touch, do not touch is low (similar touch of a button feature)
Low power consumption
Power supply for 2 ~ 5.5V DC
Touch surface can be used as positive and negative, can replace the traditional touch of a button
4 M2 screws positioning holes for easy installation
Control Interface: A total of three pins (GND, VCC, SIG), GND to ground, VCC is the power supply, SIG digital signal output pin
Power Indicator: Green LED, power on the right that is shiny;
Touch area: Similar to a fingerprint icon inside the area, you can touch the trigger finger.
Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combination;

SKU: SN1023 Categories: Other, Sensors, Touch

Description

The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption; When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode.
Jog type : the initial state is low , high touch , do not touch is low ( similar touch of a button feature )
Module can be installed in such as surface plastic, glass of non-metallic materials
In addition to the thin paper ( non-metallic ) covering the surface of the module , as long as the correct location of the touch , you can make hidden in the walls, desktops and other parts of buttonsFeatures:
Low power consumption
Power supply for 2 ~ 5.5V DC
Can replace the traditional touch of a button
Four M2 screws positioning holes for easy installation